Destination Subnet | Type the subnet mask here if you choose Subnet as |
| Destination IP Type. |
Source Start Port | Type a value as the source start port. Such value will be |
| available only TCP/UDP is selected as the protocol. |
Source End Port (optional) | Type a value as the source end port. Such value will be |
| available only TCP/UDP is selected as the protocol. |
Destination Start Port | Type a value as the destination start port. Such value will |
| be available only TCP/UDP is selected as the protocol. |
Destination End Port (optional) Type a value as the destination end port. Such value will be available only TCP/UDP is selected as the protocol.
Action | Set the action that the router will perform for the packets |
| through the protocol of IPv6. |
Accept – If the IPv6 packets fit the condition listed in this page, the router will let it pass through.
Drop - If the IPv6 packets fit the condition listed in this page, the router will block it.
Example:
Refer to the following example.
1.Use TSPC mode to connect to IPv6 network.
PC get ipv6 IP: 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
2.Connect PC to http://www.ipv6.org/ with IPv6 IP address. A message will appear from the web page:
Welcome to the IPv6 Information Page!
You are using IPv6 from 2001:5c0:1503:7400:30e4:139d:53c8:3a1e
3.Set firewall rule to block all TCP traffic from this IP address.
4.Open IPv6 >> IPv6 Firewall Setup and press Add New Rule.
In the following dialog, please configure the page with the following values.
Vigor2750 Series User’s Guide | 213 |
