Vigor2750 Series User’s Guide
22
P
PP
PP
Po
oE
E
PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE connection
for accessing the Internet. Your service provider will provide you information about user name,
password, and authentication mode.
If your ISP provides you the PPPoE connection, please select PPPoE for this router. The
following page will be shown:
User Name Assign a specific valid user name provided by the ISP.
Password Assign a valid password provided by the ISP.
Confirm Password Type the password again for confirmation.
Redial Policy If you want to connect to Internet all the time, you can choose
Always On. Otherwise, choose Connect on Demand.
Idle Time Out Set the timeout for breaking down the Internet after passing
through the time without any action. The unit is seconds. The
range is XX ~ XX.
MTU Size It means Max Transmit Unit for packet. The default
setting is 1442.
Enable The router will detect the MAC address automatically. Or,
check the box to enable MAC address cloning.
Clone MAC Address It is available when the box of Enable is checked. Click Clone
PC Address. The result will be displayed in the field of MAC
Address.