Emerson RTM-ATCA-7150 manual Cabling and Connectors, Laser, Environment

Safety Notes

Emerson Network Power Embedded Computing (ENPEC) and our suppliers take significant steps to ensure there are no bent pins on the backplane or connector damage to the boards prior to leaving the factory. Bent pins caused by improper installation or by inserting boards with damaged connectors could void the ECC warranty for the backplane or boards.

Incorrect installation of the product can cause blade damage.

Only use handles for when installing/removing the product to avoid damage/deformation to the face plate and/or PCB

Cabling and Connectors

Damage of the Product

The RJ-45 connector(s) on the face plate are either twisted-pair Ethernet (TPE) or E1/T1/J1 interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage the product.

zMake sure that TPE connectors near your working area are clearly marked as network connectors.

zVerify that the length of an electric cable connected to a TPE bushing does not exceed 100 meters.

zMake sure the TPE bushing of the product is connected only to safety extra low voltage

circuits (SELV circuits).

If in doubt, ask your system administrator.

Laser

This product is a Class 1 laser product. The use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Environment

Always dispose of used blades, system components and RTMs according to your country’s legislation and manufacturer’s instructions.

20 ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)