Hardware Installation of ATCA-7150
2.Lay the
3.Take the DIMM out of the antistatic package.
4.Make sure that two interface fixing clips are fully open. Adjust the DIMM to align it with the DIMM interface.
Product Damage
Operate the fixing clips slightly to avoid breaking them or damaging the DIMM interface.
5. Insert the DIMM in the interface along the guide rails, as shown in Figure
If there is a gap between the DIMM and the fixing clips, the DIMM is not installed properly. In this case, open the fixing clips and remove the DIMM. Then, insert the DIMM again.
6. Make sure that the fixing clips are fastened or closed firmly as shown in Figure
83 |
