Emerson RTM-ATCA-7150 manual Installing the Hard Disk

Hardware Installation of ATCA-7150

8.Install the ATCA-7150 with the DIMM replaced.

For details, see Installing the ATCA-7150 in a Powered Shelf on page 91.

Figure 3-5 Removing the DIMM

1

1

2

After replacement, check whether the OS can be loaded properly. If it can be, in the OS, check whether the displayed memory capacity is consistent with the actual one.

3.6.5Hard Disk

This section describes how to install and replace the hard disk on the ATCA-7150.

3.6.5.1Installing the Hard Disk

For more information on the installation of the hard disk, refer to the HDD Installation Sheet.

To install the hard disk, proceed as follows:

1.Wear the ESD-preventive wrist strap.

For details, see Wearing the ESD-Preventive Wrist Strap on page 75.

2.Take the hard disk to be installed out of the antistatic package.

86 ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)