Emerson RTM-ATCA-7150 manual Precautions, Electric Shock

Hardware Installation of ATCA-7150

3.4Precautions

Electric Shock

There is current in the power cords and communication cables. Touching the connectors of the power cords and communication cables may cause electric shock.

Do not touch the connectors of power cords and communication cables.

Electrostatic Discharge

Do not touch the circuit board with bare hands.

The static electricity of the human body may damage the electrostatic sensitive devices (ESSDs) on the circuit board.

Make sure that you wear an electrostatic discharge (ESD)-preventive wrist strap or antistatic glove to prevent the static electricity from hurting you or damaging the device.

Keep your personal objects such as your clothes away from the ATCA-7150 suite. To prevent the static electricity from damaging the device, it is recommended to wear antistatic clothes.

Pin Damage

If the blade is not fully aligned with the interface in the backplane, too much force may twist the pins on the blade or backplane.

Do not exert too much force when you insert the blade.

Note the following points at the time of installing RTM-ATCA-7150:

zIf an RTM is planned to be used, you must install the RTM in the slot before installing the ATCA-7150 in the paired slot. If the ATCA-7150 is installed first and shelf power is turned on the RTM must not be installed in the paired slot.

zTo take the ATCA-7150 suite, hold the captive screw on the top of the face plate with one hand and the lower edge of the blade with the other hand. Do not touch the components of the blade.

ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B) 73