Emerson RTM-ATCA-7150 manual Insertion and Removal of the ATCA-7150, Operation Description

Hardware Installation of ATCA-7150

Table 3-7describes the insertion and removal of the ATCA-7150 by using the ejector handles.

Table 3-7 Insertion and Removal of the ATCA-7150

Operation	Description
Insert the ATCA-7150	The process for inserting the ATCA-7150 is as follows:
	z When the ejector handles are not closed, the HOTSWAP LED is on
	and the ATCA-7150 is not powered on.
	z After the ejector handles are closed, the HOTSWAP LED blinks at the
	long blink rate and the ATCA-7150 requests for activation.
	z After activation, the ATCA-7150 is powered on and the HOTSWAP
	LED is off.
Remove the ATCA-7150	The process for removing the ATCA-7150 is as follows:
	z When you open the ejector handles, the HOTSWAP LED blinks at the
	short blink rate and the ATCA-7150 requests for deactivation.
	z After deactivation, the ATCA-7150 is ready for power-off.
	z When the HOTSWAP LED is on, the ATCA-7150 is powered off. At
	this time, you can remove the ATCA-7150 by holding the ejector
	handles.

Power-On and Power-Off

Table 3-8describes the power-on and power-off of the ATCA-7150 by using the ejector handles.

Table 3-8 Power-On and Power-Off of the ATCA-7150

Operation	Description
Power on theATCA-7150	Whether you close one ejector handle or both ejector handles, the ATCA-
	7150 can be powered on and work well.
Power off the ATCA-7150	When both ejector handles are opened, you can power off the ATCA-
	7150.

ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B) 97