Chapter 6
Optional Transmitter Configuration
6.1Overview
This chapter describes transmitter configuration parameters that may or may not be used, depending on your application requirements. For required transmitter configuration, see Chapter 4.
The following configuration parameters and options are described in this chapter:
•Special measurement units (see Section 6.4)
•Cutoffs (see Section 6.5)
•Damping (see Section 6.6)
•Update rate (see Section 6.7)
•Flow direction (see Section 6.8)
•Events (see Section 6.9)
•Slug flow (see Section 6.10)
•Fault handling (see Section 6.11)
•Digital communications settings (see Section 6.12)
•Variable mapping (see Section 6.13)
•Device settings (see Section 6.14)
•Sensor parameters (see Section 6.15)
6.2Default values
Default values and ranges for the most commonly used parameters are provided in Appendix A.
6.3Parameter location within ProLink II
For information on parameter location within the ProLink II interface, see Appendix C.
6.4Creating special measurement units
If you need to use a
Using the Transmitter
Optional Configuration
Filler Configuration
Using the Filler
Configuration and Use Manual | 35 |