Emerson Process Management 1500 1Run Filler displays and controls, Display/Control Description

Using the Filling and Dosing Application

Table 8-1Run Filler displays and controls

Display/Control		Description
Fill Setup	Current Total	Displays the running fill total, updated periodically, for the current fill.
		This value is not updated between fills. However, if flow is present while a fill is
		paused, the value is updated.
	Reset Fill Total	Resets the fill total to 0.
	Current Target	Displays the target quantity for the current fill.
		• To change this value, enter the new target value and click Apply.
		• You cannot change the target while a fill is in progress, unless the fill is
		paused.
	AOC Coeff	Displays the factor used to adjust the target, if AOC is enabled.(1)
		• To change this value, enter the new AOC value and click Apply. WARNING:
		Writing to this parameter will overwrite any existing AOC calibration results.
		• You cannot change the AOC coefficient while a fill is in progress, whether the
		fill is currently flowing or is paused.
Fill Control	Begin Filling	Starts the fill.
		The fill total is automatically reset before filling begins.
	Pause Filling	Temporarily stops the fill.
		The fill can be resumed if the fill total is less than the fill target.
	Resume Filling	Restarts a fill that has been paused.
		Counting resumes from the total at which the fill was paused.
	End Filling	Permanently stops the fill or purge.
		The fill cannot be resumed.
	Begin Purge	Begins a manual purge by opening the secondary valve.
		You cannot begin a purge while a fill is in progress.
		You cannot begin a fill while a purge is in progress.
	End Purge	Ends a manual purge by closing the secondary valve.
	Begin Cleaning	Opens all valves (except purge valve) that are assigned to a transmitter output.
		Cleaning cannot be started if a fill or purge is in progress.
	End Cleaning	Closes all valves that are assigned to a transmitter output.
AOC	Start AOC Cal	Begins AOC calibration.
Calibration
	Save AOC Cal	Ends AOC calibration and saves the calculated AOC coefficient.
	Override Blocked Start	Enables filling if the fill has been blocked by:
		• Slug flow
		• A core processor fault
		• The last measured flow rate is too high, as indicated by the corresponding
		status LED (see Table 8-2).
	Reset AOC Flow	Resets the last measured flow rate to zero, to bypass the condition indicated by
	Rate(2)	the AOC Flow Rate Too High status LED (see Table 8-2).
		If the flow rate is too high, and this is not a one-time condition:

• And you are using standard AOC calibration, try resetting the AOC flow rate (see below). If this does not clear the condition, repeat AOC calibration.

• And you are using rolling AOC calibration, overriding the blocked start once or twice should correct the condition.

Using the Transmitter

Optional Configuration

Filler Configuration

Using the Filler

Configuration and Use Manual 69