E-16 UPGRADE 2350A GC S/W AND 2350 EPROMS
MON2000
Reprogramming the DiskOnChip JULY 2010
9. The Protected Mode Program screen
displays. Verify that a "cold start - initial"
message is displayed in the middle of the
screen and LED D2 is blinking on the CPU
assembly.
10.Press ESC to exit the program and power
down.
11.Carefully remove the cable from J1 and J10
to prevent cracking the connector housing.
Install the program label on the end of
DiskOnChip opposite the serial number.
E.8.2 Reprogramming the DiskOnChip
Reprogram the DiskOnChip using the
following instructions.
1. Install either the programmed DiskOnChip
into socket U1 on the CPU assembly (noting
the orientation of pin 1) or install the
complete CPU assembly into card cage.
2. Plug the floppy drive cable into J10 on the
CPU assembly and the keyboard cable into
J1 on the CPU assembly.
3. Turn on the power. The CPU assembly
reboots and displays the Systems
Configuration window. The speaker on the
CPU will chirp and the monitor will prompt
"ENTER NEW DATE (mm-dd-yy)". Press
ENTER
"ENTER NEW TIME:". Press ENTER.
The A:\> prompt displays. Verify that the
programming disk is the current revision
specified on the work order package and
insert into the floppy drive. Type C:, then
ENTER to change to the ‘C’ drive.