INSTALLATION AND SETUP 2-35
MON2000
JULY 2010 Dial-up Connection
7. Click the button to accept the
changes. While connecting, MON2000 dials
the number, attempts to connect via the
selected modem and displays progress
messages. A message box appears when a
connection has been made or if the attempt
to connect fails.
Once a connection has been established and
while MON2000 remains connected via the
modem, the Connect button is disabled and
the Disconnect button is enabled.
If the connection fails at any time,
MON2000 displays a message in the GC
Status bar that it has been disconnected.
You can end the connection from the
File>Disconnect menu, by clicking the
disconnect icon on the MON2000 toolbar, or
by exiting MON2000.
When you start MON2000 after the
parameters are established, you can connect
to the GC via the File>Connect menu or by
clicking the Connection icon on the
MON2000 toolbar.
If you are using the Modbus RTU protocol, the values for baud
rate, data bits, stop bits, and parity must match the settings
you configured in the Modem Properties dialog.
These values are required to correctly calculate character
timing.