Emerson Process Management OXYMITTER 4000 instruction manual List of Tables

Instruction Manual

IB-106-340C Rev. 4.1 July 2004

Hazardous Area Oxymitter 4000

Figure 8-10.	Fault 8, Low Heater Temp	8-12
Figure 8-11.	Fault 9, High Heater Temp	8-13
Figure 8-12.	Fault 10, High Cell mV	8-14
Figure 8-13.	Fault 11, Bad Cell	8-15
Figure 8-14.	Fault 12, EEprom Corrupt	8-16
Figure 8-15.	Fault 13, Invalid Slope	8-17
Figure 8-16.	Fault 14, Invalid Constant	8-18
Figure 8-17.	Fault 15, Last Calibration Failed	8-19
Figure 8-18.	Probe Leakage Paths	8-20
Figure 9-1.	Membrane Keypad	9-2
Figure 9-2.	Inside Right Cover	9-4
Figure 9-3.	Hazardous Area Oxymitter 4000 with Integral Electronics – Exploded View	9-8
Figure 9-4.	Hazardous Area Oxymitter 4000 with Remote Electronics – Exploded View	9-9
Figure 9-5.	Electronic Assembly	9-10
Figure 9-6.	J8 Connector	9-11
Figure 9-7.	Fuse Location	9-12
Figure 9-8.	Heater Strut Assembly	9-14
Figure 9-9.	Cell Replacement Kit	9-15
Figure 9-10.	Ceramic Diffuser Element Replacement	9-16
Figure 9-11.	Contact and Thermocouple Assembly Replacement	9-18
Figure 11-1.	Cell Replacement Kit	11-2
Figure 11-2.	Probe Disassembly Kit	11-3

LIST OF TABLES

Table 1-1.	Product Matrix	1-14
Table 1-2.	Calibration Components	1-16
Table 1-3.	Intelligent Multiprobe Test Gas Sequencer Versions	1-16
Table 3-1.	Logic I/O Configuration (as set at HART/AMS or LOI)	3-4
Table 4-1.	Logic I/O Configuration (as set at HART/AMS or LOI)	4-4
Table 7-1.	Logic I/O Configuration (as set at HART/AMS or LOI)	7-4
Table 8-1.	Diagnostic/Unit Alarm Fault Definitions – Membrane Keypad Only	8-4
Table 8-2.	Diagnostic/Unit Alarm Fault Definitions – LOI	8-4
Table 11-1.	Replacement Parts for Probe	11-1
Table 11-2.	Replacement Parts for Electronics	11-4

iv Rosemount Analytical Inc. A Division of Emerson Process Management