Epson Scan 2500 service manual Removing the Right and Left LD Roller Assembly, Spring on the hook

EPSON Stylus Scan 2500 Revision A

4.6.4.2 Removing the Right and Left LD Roller Assembly

1.Disassemble the ASF assembly and remove the paper feed roller assembly and hopper assembly from the ASF assembly. (Refer to Section 4.6.4.)

2.Take out the right and left compression springs 1.66 from the back of the hopper assembly.

3.Pull out the cam part of the hopper assembly from the hole located on the frame of the right LD roller assembly,

4.Pull out the LD roller shaft. The paper feed roller assembly and hopper assembly should be disconnected by now.

5.Release the hook of LD roller assembly at the shaft hole of the paper feed roller assembly. Also, release the fixed hook of the cover roller LD and remove the LD roller assembly.

	When installing the LD roller assembly, make sure
C H E C K
	that the hooks are hung on the paper feed
P O I N T
T	assembly.

During assembly, when setting the compression spring 1.66 to the spring installation position in the paper feed assembly, hang the spring on the hook temporarily. Also, do not forget to release the hooks of these springs from the holes located on the back of paper feed assembly by rotating the spring. (Refer to the figure below.)

LD Roller Cover

(Right and Left) Compression Spring 1.66

+

Paper Feed Holder

Sheet

LD Roller Assembly

(Right and Left)

Paper Feed Assembly

(Right and Left)

During assembly, set the compression spring

1.66in the position for spring installation of the paper feed assembly and hang the bent part of

the spring on the hook.

Figure 4-10. Disassembly of Paper Feed Roller Assembly

Disassembly & Assembly Disassembling the Printer Mechanism 103