EPSON Stylus Scan 2500

Revision A

5.3.3 Initial Ink Charge Operation

There is no ink in the ink path of a spare printhead and printer mechanism when first installed; therefore, after replacing either of these two parts, you need to perform an initial ink charge.

1.Enter the Production menu as described in “Using the Service- Adjustment Program” on pag e116.

2.On the Production menu (Figure 5-6),select Ink Charge. Then click OK in the dialog box that appears.

It takes approximately 90 seconds for the ink charge operation to complete.

5.3.4 Bi-D Adjustment

You perform this adjustment to correct differences in printing positions, which is caused by slippage of printing timing in right and left directions during the Bi-directional printing. Therefore, you need to perform this adjustment after performing the following operations.

 

Replacing the printer mechanism

 

Replacing the main board

 

Replacing the CR motor

 

Replacing the Carriage Assembly

T

Replacing the Printhead

1.Enter the Production menu as described in “Using the Service- Adjustment Program” on page 116.

2.On the Production menu (Figure 5-6),select Bi-d Adj. - Normal. The Bi- d Adjust dialog box appears.

3.Click OK in the dialog box that appears to print adjustment patterns

with the current settings.

Adjustment

Using the Service-Adjustment Program

122

Page 124
Image 124
Epson Scan 2500 service manual Initial Ink Charge Operation, Bi-D Adjustment