Epson Scan 2500 service manual Overview

EPSON Stylus Scan 2500 Revision A

4.1 Overview

This chapter describes procedures for disassembling the main components of the EPSON Stylus Scan 2500. Unless otherwise specified, disassembly units or components can be reassembled by reversing the disassembly procedure. Therefore, no specific assembly procedures are included in this chapter, but special points regarding re-assembly are given under the heading “CHECK POINT”. Any adjustments required after disassembling the units are described under the heading “REQUIRED ADJUSTMENT”.

4.1.1Precautions for Disassembling the Printer

See the precautions given under the headings “WARNING” and “CAUTION” below, before disassembling or assembling the EPSON Stylus Scan 2500.

W A R	Disconnect the power cable before disassembling or
	assembling the printer.
	Wear protective goggles to protect your eyes from
	ink. If ink gets in your eye, flush the eye with fresh
	water and see a doctor immediately.
	If ink comes into contact with your skin, wash it off
	with soap and water. If irritation occurs, contact a
￿	physician.
	A lithium battery is installed on the MAIN Board of
	this printer. Be sure to observe the following
	instructions when servicing the battery:
		Keep the battery away from any metal or other batteries
		so that electrodes of the opposite polarity do not come in
		contact with each other.
		Do not heat the battery or put it near fire.
	￿	Do not solder on any part of the battery. (Doing so may
		result in leakage of electrolyte from the battery, burning
		or explosion. The leakage may affect other devices close
		to the battery.)
		Do not charge the battery. (An explosion may be
		generated inside the battery, and cause burning or
		explosion.)
		Do not dismantle the battery. (The gas inside the battery
		may hurt your throat. Leakage, burning or explosion may
		also be resulted.)

Do not install the battery in the wrong direction. (This may cause burning or explosion.)

Disassembly & Assembly Overview 75