Epson Scan 2500 Removing the power supply board upper frame, Remove two screws On the left side

EPSON Stylus Scan 2500 Revision A

Remove two screws

on the left side.

NOTE: The picture above shows the scanner home-position sensor and maintenance cover open sensor cables still attached to the left side frame. You can either leave them as shown above or remove them along with the option connector cable as describe in attached to the side frame in “Removing the scanner support frame” on pag e84.

5.Carefully remove the paper eject assembly to avoid scratching the surface on any of the metal parts.

4.3.7 Removing the power supply board upper frame

1.Remove the rear cover and top cover as described in “Removing the Housing” on page 82.

2.Remove the side covers as described in “Removing the side covers” on page 84.

3.Remove the scanner support frame as described in “Removing the scanner support frame” on pag e84.

4.Remove one connector for the AC cable, and one screw (CBS 3x6) and one spacer.

Spacer and connector

Disassembly & Assembly Removing the Housing 86