EPSON Stylus Scan 2500

Revision A

4.6.4 Removing the ASF Assembly

1.Remove the housing. (Refer to Section 4.3.)

2.Release the fixed hook from the inside of the printer mechanism and remove the gear 34 from the roller shaft in the ASF assembly.

3.Remove the cables from the cable hook on the printer mechanism and the hook on the ASF assembly.

4.After removing 2 screws (one No.7 screw and one CR shaft installation screw), remove the ASF assembly, releasing the protrusion on the left side of the ASF assembly from the hole in the frame.

5.With one hand move the paper depressor to the left and up, and with the other hand remove the ASF assembly, releasing the protrusion on the left side of the ASF assembly from the hole in the frame.

CR Shaft

Installation Screw

CBS Sems screw

with a Washer

Make sure that the

protrusion in the ASFGear 34 Assembly are in these holes

on the frame when installing

the ASF assembly.

C H E C P O I N

T

When installing the ASF assembly, make sure that

K

the frame and ASF assembly are attached each other

T

without any space between them.

Screws for ASF assembly should be used at the following positions. (Looking from the back of printer)

-Right:CR shaft installation screw

-Left:Screw No.7 (+Bind, S- tight, Sems R2; with a plain washer)

Move the paper

ASF

depressor up and

protrusion

out of the way.

 

Figure 4-8. Removing the ASF Assembly

Disassembly & Assembly

Disassembling the Printer Mechanism

100

Page 101
Image 101
Epson Scan 2500 service manual Removing the ASF Assembly