EPSON Stylus Scan 2500

Revision A

Figure 5-8. Sample of Head Angular Adjustment Pattern

NOTE: In the above figure, Head Katamuki means Head Angle.

4.Loosen the screw securing the printhead on the carriage. (You don't need to remove it completely.)

Printhead

securing screw

Figure 5-9. Screw Position

NOTE: Make sure to loosen this screw. Otherwise, the printhead angle will not change even if the adjustment lever moves.

5.Look very closely at the black/magenta lines in the bottom pattern and move the adjustment lever to center the magenta lines between the black lines. The figure below shows how to move the lever to correct a misaligned pattern.

To move this down

Correct condition = vertical

spacing is even

Move the lever

to the rear

To move this up

Move the lever

to the front

Adjustment lever

Figure 5-10. Lever Operation

6.After changing the position of the adjust lever, select Print - Angular Adj. again from the Production Menu.

7.Verify the pattern on the printout again.

8.Repeat this process until the combination pattern of black/magenta is correct.

Adjustment

Using the Service-Adjustment Program

125

Page 127
Image 127
Epson Scan 2500 service manual Sample of Head Angular Adjustment Pattern, Printhead Securing screw