Extron electronic 68-1383-01 REV. E manual Picture Settings, Creating a tie

Creating a tie

Select and switch an input as follows:

1.Click the Video Only, Audio Only, or Video & Audio button to select video, audio, or both for switching (audio follow or audio breakaway). Each mouse click on a button toggles the other two buttons off.

2.Move the mouse over the matrix of input and output selection buttons. Click a button to create a pending tie (if a tie does not exist) or pending untie (if a tie exists) of the input and output associated with that button. A “P” (for pending) appears in the button.

NOTES: • If you lose track of the input and output associated with a specific

button, let the mouse rest over one of the tie buttons for a moment. A

field pops up (as shown on figure 84) that identifies the input and output

for that button.

• To tie an input to all outputs, click that input number.

3.Click the Take button to make the configuration changes or the Cancel button to abandon the configuration changes.

Picture Settings Page

The Picture Settings page provides a way to set the input level/peaking, the output pre- peaking, and the input and output skew settings. Access the Picture Settings page (see figure 85) by clicking the Picture Settings link on the Control page.

Set and View Ties

Refresh

MTPX Configuration

I/O Settings

Global Presets

Figure 85. Picture Settings Page

MTPX Plus Series • HTML Operation 138