Extron electronic 68-1383-01 REV. E manual Reset Mode Comparison/Summary

	Table 7.	Reset Mode Comparison/Summary
Mode	Activation		Result	Purpose/Notes
1	Hold down the recessed Reset button		The switcher reverts to the factory default	Use mode 1 to revert
	while applying power to the switcher.		firmware. Event scripting will not start if the	to the factory default
	NOTE: After a mode 1 reset is		switcher is powered on in this mode. All user files	firmware version if
			and settings (such as drivers, adjustments, and IP	incompatibility issues
	performed, update the		settings) are maintained.	arise with user-loaded
	switcher firmware to the		NOTE: If you do not want to update	firmware.
	latest version. Do not
	operate the switcher		firmware, or you performed a mode 1
	firmware version that		reset by mistake, cycle power to the
	results from the mode 1		switcher to return to the firmware
	reset. If you want to		version that was running before
	use the factory default		the mode 1 reset. Use the 0Q SIS
	firmware, you must		command to confirm that the factory
	upload that version		default firmware is no longer running
	again (see the “Matrix		(look for the asterisk [*] following the
	Software”section for		version number.
	details on uploading
	firmware).
3	Hold down the Reset button for about 3		Mode 3 turns events on or off. During resetting,	Mode 3 is useful for
	seconds, until the Reset LED blinks once,		the Reset LED flashes 2 times if events are starting, 3	troubleshooting.
	then press and release Reset (<1 second)		times if events are stopping.
	within 1 second.
4	Hold down the Reset button for about		Mode 4:	Mode 4 enables you
	6 seconds, until the Reset LED blinks		• Enables ARP capability.	to set IP address
	twice (once at 3 seconds and again at 6		• Sets the IP address to the factory default.	information using ARP
	seconds). Then press and release Reset		• Sets the subnet address to the factory default.	and the MAC address.
	(<1 second) within 1 second.		• Sets the gateway address to the factory default.

•Sets port mapping to the factory default.

•Turns DHCP off.

•Turn events off.

The Reset LED flashes four times in quick succession during the reset.

5	Hold down the Reset button for about	Mode 5 performs a complete reset to factory	Mode 5 is useful if
	9 seconds, until the Reset LED blinks	defaults (with the exception of the firmware):	you want to start over
	three times (once at 3 seconds, again	• Does everything mode 4 does.	with configuration and
	at 6 seconds, and then again at 9	• Resets most all real time adjustments, including:	uploading or to replace
	seconds). Then press and release Reset	clears all ties and presets,	events.
	(<1 second) within 1 second.	clears all audio or RS-232 mutes,
	NOTE: Mode 5 reset clears	clears all I/O grouping,
		clears all input level/peaking,
	most adjustments. To	clears all skew adjustments,
	save these settings,	clears all output pre-peaking,
	use the Windows-	disables all RS-232 output inserts,
	based Matrix Switchers	sets all audio/RS-232 wire pairs to audio,
	Control Program and the	clears all audio settings.
	File > Save MATRIX	• Resets all IP options.
	settings as...	• Removes/clears all files for the switcher.
	selection before you	The reset LED flashes four times in quick succession
	perform this reset (See	during the reset.
	the “Matrix Software”
	section.

MTPX Plus Series • Operation 65