Extron electronic 68-1383-01 REV. E manual Front Panel Configuration Port, Reset Button

Reset Button

l Reset button — The Reset button initiates two levels of reset to the matrix	RESET
switcher. For two different reset levels, press and hold the button while the
switcher is running or while you power up the switcher.

See “Rear Panel Operations” in the “Operation” section for details.

•Rear panel (mode 5) system reset — Press and hold the Reset button until the Reset

LED blinks three times (approximately 9 seconds), then release the button and push it again. This reset clears all ties and presets and resets all audio gains to 0 dB.

•Hard reset — Press and hold the Reset button while powering up the switcher to perform all of the mode 5 reset functions and restore the switcher to the default factory conditions.

NOTE: Hard reset does not clear the current configuration.

Power Connection

mAC power connector — Plug a standard IEC power cord into this connector to connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.

WARNING: The power connector is wired double pole with neutral fusing.

Front Panel Configuration Port

This front panel configuration port serves a similar communications function as the rear panel Remote port, but it is easier to access than the rear port after the matrix switcher has been installed and cabled.

NOTES: • The Configuration port is independent of the rear panel Remote port and is

not affected by changes to the protocol of the rear panel port.

• A front panel Configuration port connection and a rear panel Remote port connection can both be active at the same time.

Figure 14 shows the Configuration port for the various MTPX Plus models.

All other MTPX Plus models

MTPX Plus 128

CONTROLI/O

	I	1	2	3	4
	N
	P
	U
	T
CONFIG	O	1	2	3	4
	U
	PT
	U
	T

CONFIG

ENTER PRESET VIEW ESC VIDEO AUDIO

MTPX PLUS SERIES SWITCHER

14 15

Figure 14. Front Panel Configuration Port

nConfiguration port (MTPX Plus 128 only) — A mini USB B port.

oConfiguration port — A 2.5 mm mini stereo jack. The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable, part number 70-335-01(see figure 15, on the next page), can be used for this connection.

MTPX Plus Series • Installation 20