FARGO electronic 410 manual Setting up the Printer Driver, Windows 98 / Windows Millennium

RESTRICTED USE ONLY Fargo Electronics, Inc.

Setting up the Printer Driver

Once the Printer Driver has been installed, you may need to select Printer Driver options other than the default settings. To open the Printer Driver setup window, please refer to the following steps for the specific operating system:

IMPORTANT! Before you can print, the Printer Driver must be installed and the Printer's power and USB cables must be connected. Also, be sure Ink and Card Cartridges are installed. Do not connect the Printer to the PC before asked to do so.

Windows 98 / Windows Millennium

Step Procedure

1Select Start button, Settings and Printers.

2Double-click on the specific Card Printer and select Properties.

Windows 2000 / Windows XP

Step	Procedure
1	Select the Start button, Settings and Printers.
2	Double-click on the specific Card Printer and select Properties, then click on
	Printing Preferences...
	(Note: If you would like to permanently save the Printer Driver settings so you
	will not need to change them again, do so through the main Printer Driver setup
	window described above. Although most applications do allow you to change
	these same Printer Driver options from their own Print screens, the settings may
	not be permanently saved.)
3	To change or verify the appropriate Printer Driver options for the print job, please
	refer to the topics describing each of the Printer Driver's tabs.

CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0) 103