FARGO electronic 410 manual Technician Handbook for CardJet Card Printers

RESTRICTED USE ONLY Fargo Electronics, Inc.

Technician Handbook for CardJet Card Printers (continued)

Topic	Description
Card Printing	The Firmware correctly detects the condition and indicates a fatal error
Jam	condition via Card LED and a PC on-screen error message via the
	Driver Operator Interface￿when a print job and the Printer are
	configured with anomalous conditions intended to induce a card printing
	jam.
	Troubleshooting Instructions. See Section 2):
	• After an error has been detected and reported, you can open the
	cover, remove the jammed card and then close the cover and press
	the Card button to continue the print job starting with a fresh card.
Card Sensor	The Fargo Controller turns the LED on/off depending on the Card
condition (turns	Sensor condition. See the Interpreting the LED Lights procedure on
LED on/off;	￿
both 410/C7	page 76. (Note: When no card is present, the LED is on and nothing
	interrupts the IR emission.)
models)	This Sensor is described as follows:
	• Detect card jam: The Card Sensor is used to determine the card
	position in case of a jam, as well as for service purposes.
	• Detect card edge: The Fargo Controller detects if there was a
	leading or trailing edge of a card detected.
	Continued on the next page

CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0) 50