FARGO electronic 410 manual Powering up the Card Printer, Outlet

RESTRICTED USE ONLY Fargo Electronics, Inc.

Powering up the Card Printer

The power supply within the Printer is a universal power supply properly configured for the power used in the (respective) country. To connect power to the Printer, locate the appropriate power cord for the country and refer to the following steps:

Step	Procedure
1
	CAUTION! The (included) two (2) power cords are designed for use
	only with the Card Printer. (Note: If you have any doubts about the plug
	configuration or the voltage, do not attempt to use the Printer. Contact the Fargo
	authorized reseller for information on the correct power configuration.)
	Locate the power cord included with the Card Printer.
2	Place the power cord into the power cord port of the Card Printer.
3	Place the AC power plug end of the power supply cord into an available wall
	outlet.
4	Press the Power button if you wish to turn the Printer ON or OFF. (Note: If the
	Printer will not be used for a long period of time, unplug the power cable to the
	Card Printer to ensure that all power is disconnected from the unit.)

CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0) 28