FARGO electronic 410 manual Using the Verification option under Magnetic Encoding

RESTRICTED USE ONLY Fargo Electronics, Inc.

Using the Verification option under Magnetic Encoding

Use the Verification option, which instructs the Printer to verify that all magnetic data has been correctly encoded on each card. (Note: With either of these options, the number of verification retries can be specified. A range of 1 to 5 retries is available.)

Step Procedure

1Select the Auto Eject 1st Error option, which instructs the Printer to automatically eject a card containing miss-verified magnetic data (that cannot be verified). (Note: This option is helpful since magnetic stripe verification can at specific times require more than a single pass.)

•Manual Eject mode: Only the first miss-verified card would be automatically ejected. If a second consecutive card cannot be verified, the Printer will signal an error and go into a Manual Eject mode.

•Auto Eject option: The Auto Eject option is the most direct means of dealing with miss-verified cards. However, it may be undesirable (if batch printing) since miss-verified blank cards are ejected into the same stack as verified printed cards.

OR

Select the Manual Eject Each Error option so the Printer will signal an error on its LCD display (stating that the magnetic data could not be verified). (Note: When this occurs, press the Cancel soft key to manually eject the miss-verified card.)

CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0) 121