FARGO electronic 410 manual Technician Handbook for CardJet Card Printers

RESTRICTED USE ONLY Fargo Electronics, Inc.

Technician Handbook for CardJet Card Printers (continued)

Term	Description
Power Supply	Fargo supplies both cord sets for Internal power supply. (Note: This
	provides a dual power supply (110v/220v).)
Printer	1.	Connect the Printer to a domestic US power source via appropriate
connected to a		power cord, to start-up the Printer. (Note: Normal device
domestic US		initialization and Firmware downloading. Printer start-up is initiated.
power source		The cards are printed with acceptable color reproduction and image
		placement when the Operator selects normal Printer Driver
		preference options and initiates a print job.)
	2.	Select the normal Printer Driver preference options and start a print
		job. Ensure that the cards are printed with acceptable color
		reproduction and image placement.
Printer Drive	The Printer Driver Fuel Gauge correctly provides the Operator with a
Fuel Gauge	display of the estimated amount of ink remaining in the Cartridge when
(used for	the Operator requests it.
monitoring ink	•	Ink Levels: The Printer is set up to ensure the appropriate ink
levels)
		levels exist before starting each print job.
	•	Monochrome/Color Cartridge: The Printer provides a fuel gauge
		in Printer Driver to monitor both monochrome and color Cartridge.
		Each Cartridge is monitored individually.
	•	Ink Low message: The Fuel Gauge provides an onscreen
		Operator warning for Ink Low.
	•	Ink Out message: The Fuel Gauge provides a definitive Ink Out
		message on screen and LED flash. (Note: It resumes without error
		after an Ink Cartridge is replaced if ink runs out in the middle of a
		batch print.)
		Continued on the next page

CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0) 66