FARGO electronic 410 manual Grounding Device Safeguards Always wear an appropriate

RESTRICTED USE ONLY Fargo Electronics, Inc.

Additional Safety Precautions for CardJet Technicians (review carefully)

Symbol	Critical Instructions for Safety purposes
Danger:	Before operating the unit, please read the following safety
	precautions carefully:
	• Fire or Shock Hazard: Prevent fire or shock hazard by not
	exposing the unit to rain or moisture.
	• Electronic Shock: Reduce the risk of electronic shock by not
	removing the front, top or back Panels. No Operator-serviceable
	parts inside. (Technician Note: Refer servicing to qualified
	service personnel.)
	• Correct Voltage Rating: Operate the unit only on 100-240 VAC,
	50/60 Hz. (Technician Note: If you have any doubt as to whether
	you have a unit with the correct voltage rating for the country's
	power supply, DO NOT attempt to use the unit. Contact the dealer
	or the factory.)
	• Liquid or Solid Object: Stop operation immediately if any liquid
	or solid object should fall into the cabinet. (Technician Note:
	Unplug the unit and have it checked by qualified service
	personnel.)
	• AC power cord: Use only the AC power cord included with this
	unit or an equivalent cord.
	• ESD procedures: Be sure to observe all established Electro-
	Static Discharge (ESD) procedures while handling cables in or
	near the Circuit Board.
	• Grounding Device Safeguards: Always wear an appropriate
	personal grounding device, such as a wrist strap with integral
	resistor, connected to an ESD ground to avoid potential damage.
	• Electrostatic Sensitive Device: At a minimum, make positive
	contact with the bare metal chassis of the Printer with the hand
	before proceeding with the procedure. (Technician Note: This
	device is electrostatic sensitive. It may be damaged if exposed to
	static electrical discharges. Discharges may be generated by
	various means, such as walking on a carpeted floor.)

CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 5.0) 98