Fluke 8842a instruction manual Adjusting the Handle, Rack Mounting Kits

Operating Instructions 2

INSTALLATION

2-5. Adjusting the Handle

The handle provides two viewing angles for bench-top use. To adjust its position, pull the ends out to a hard stop (about 1/4 inch on each side) and rotate it to one of the four stop positions shown in Figure 2-2. To remove the handle, adjust it to the vertical stop position and pull the ends all the way out.

2-6. Rack Mounting Kits

You can mount the 8842A in a standard 19-inch rack panel using the accessory rack mounting kits shown in Figure 2-3. To install the Single Rack Mount Kit, remove the handle and handle mounting plates, and attach the rack ears with the screws provided (Figure 2-4). The Dual Rack Mount Kit is installed similarly. (Both kits include mounting instructions.)

The rear feet may be rotated 180 degrees to clear a narrow rack space.

f2-02.wmf

Figure 2-2. Adjusting the Handle

f2-03.wmf

Figure 2-3. Rack-Mount Kits

2-3