Fluke 8842a instruction manual Remote Programming

Chapter 3

Remote Programming

		Title	Page
3-1.	INTRODUCTION		3-3
3-2.	CAPABILITIES		3-3
3-3. BUS SET-UP PROCEDURE			3-3
3-4. AN OVERVIEW OF REMOTE OPERATION			3-4
3-5. A NOTE ABOUT EXAMPLES			3-6
3-6.	DEVICE-DEPENDENT COMMAND SET		3-6
3-7.	Bn (Offset Commands)		3-9
3-8.	Cn (Calibration Commands)		3-9
3-9.	Dn (Display Commands)		3-9
3-10.	Fn (Function Commands)		3-10
3-11.	Get Commands		3-10
3-12.	G0	(Get Instrument Configuration)	3-12
3-13.	G1	(Get SRQ Mask)	3-12
3-14.	G2	(Get Calibration Prompt)	3-12
3-15.	G3	(Get User-Defined Message)	3-13
3-16.	G4	(Get Calibration Status)	3-13
3-17.	G5	(Get IAB Status)	3-14
3-18.	G6	(Get YW Status)	3-14
3-19.	G7	(Get Error Status)	3-14
3-20.	G8	(Get Instrument Identification)	3-15
3-21.	N (Numeric Entry Command)		3-15
3-22.	Put Commands		3-15
3-23.	P0 (Put Instrument Configuration)		3-15
3-24.	P1 (Put SRQ Mask)		3-16
3-25.	P2	(Put Calibration Value)	3-16
3-26.	P3	(Put User-Defined Message)	3-17
3-27.	Rn (Range Commands)		3-17
3-28.	Sn (Reading Rate Commands)		3-17
3-29.	Tn (Trigger Mode Commands)		3-18
3-30.	Wn (Terminator Commands)		3-19
3-31.	X0	(Clear Error Register Command)	3-19
3-32.	Yn (Suffix Commands)		3-19
3-33.	Z0 (Self-Test Command)		3-19
3-34.	(Device-Clear Command)		3-20

3-1