Fluke RPM4 Measurement is finished, Lower limits, An internal device failure has occurred, SS%n

RPM4™ OPERATION AND MAINTENANCE MANUAL

SN

Purpose	To read the serial number of the RPM4.
Query	“SN?”
Classic	“SN”
Remarks	The RPM4 is serialized. The serial number can be read using this program message.
Example	Query sent:		“SN?”
(enhanced)	Query reply:		“321”
Example	Sent:		“SN”
(classic)	Reply:		“321”
See Also	3.5.5.4
SR
Purpose	Read the next available Ready/Not Ready status.
Query	“SR?”
Classic	“SR”
Optional Suffix	“n”	The active Q-RPT is assumed if no suffix is given.
		‘1’	Specify the Hi Q-RPT if the Hi and Lo Q-RPTs are NOT OFF
			Specify the HL Q-RPT if the Hi and Lo Q-RPTs are OFF
		‘2’	Specify the Lo Q-RPT
		‘3’	Specify the HL Q-RPT if the HL Q-RPT is active
Remarks	The current Ready status can be read using this program message.
	Possible replies:
	“NR”	The pressure is not ready within the limits defined by the stability criterion.
	“R ”	The pressure meets the ready criteria. The status is replied when the next pressure
		measurement is finished.
	“OL”	The pressure of one of the active Q-RPTs has exceeded the user defined upper or
		lower limits.
	“OP”	The pressure of one of the Q-RPTs has exceeded the Q-RPT’s maximum limits.
	“ER”	An internal device failure has occurred.
Example	Query sent:		“SR?”
(enhanced)	Query reply:		“NR”
Example	Sent:		“SR”
(classic)	Reply:		“NR”
See Also	“PR”, “PRR”, “HS”, “SS”, “UL”, “LL” Commands
	3.2.1, 3.4.4, 3.4.4.1
SS%n
Purpose	Read or set the current stability limit as a % of range.
Command	“SS% limit”
Query	“SS%?”
Classic	“SS%=limit”
	“SS%”
Optional Suffix	“n”	The active Q-RPT is assumed if no suffix is given.
		‘1’	Specify the Hi Q-RPT if the Hi and Lo Q-RPTs are NOT OFF
			Specify the HL Q-RPT if the Hi and Lo Q-RPTs are OFF
		‘2’	Specify the Lo Q-RPT
		‘3’	Specify the HL Q-RPT if the HL Q-RPT is active
Arguments	limit:		The stability limit in %FS of the current active range.
Remarks	The stability limit can be read and set as a percent of the full scale range of the Q-RPT range.
Example	Cmd sent:		“SS% .1”
(enhanced)	Query reply:		“0.10 %”(No reply from GPIB-488)
Example	Cmd sent:		“SS%? .1”
(enhanced)	Query reply:		“0.10 %”
Example	Sent:		“SS%=.1”
(classic)	Reply:		“0.10 %”
Errors	ERR# 6:		The argument was invalid.
	ERR# 10:		Invalid or missing command suffix.
See Also	“SS”
	3.4.3

© 2004-2007 DH Instruments, a Fluke Company Page 104