Fluke RPM4 manual Freeze, Clean, Psi a zHi F

3. OPERATION

3.3.6.6Freeze

PURPOSE

To activate the Freeze DISPLAY.

See Section 3.3.6,  Principle.

OPERATION

To activate the Freeze DISPLAY press [DISPLAY], <6Freeze>. Pressing <6Freeze> returns to the main run screen with the Freeze DISPLAY active.

With the Freeze DISPLAY active the main run screen is:

1.Pressure measured by active range of RPM4 when [ENT] was pressed (displays 0.00 by default when Freeze DISPLAY is first activated).

99.135 psi a zHi F 99.2133

Pressing [ENT] causes the current pressure measured by the active RPM4 Q-RPT to be captured and displayed.

If the pressure measurement unit, mode or range is changed while the Freeze DISPLAY is active, the Freeze value defaults back to zero.

To go to a DISPLAY other than Freeze, press [DISPLAY] and make a new DISPLAY choice (see Section 3.3.6).

3.3.6.7Clean

PURPOSE

To activate the Clean DISPLAY.

See Section 3.3.6,  Principle..

The AutoTest function (see Section 3.3.10) to AutoRange RPM4 based on DUT characteristics and run an automated test sequence is accessed by pressing [ENT] from the Rate run screen.

Page 41 © 2004-2007 DH Instruments, a Fluke Company