Fluke RPM4 manual 2 2RES Resolution, Deleting Autorange Ranges, Save range A700K Hi kPa 300g/100a

3. OPERATION

Once the AutoRange range is set up as desired, press [SETUP], <1range>, <1save>. The display is:

1.Indication that this is a range to be saved.

2.Designator and position of the Q-RPT used by the range to be saved.

3.Pressure unit of measure of the range to be saved.

4.Full scale pressure of the range to be saved in gauge mode and absolute mode if available.

Save range A700K Hi kPa 300g/100a

Press [ENT] to save the range or [ESC] to return to the MAIN RUN screen without saving the range.

Default (<DF>) Q-RPT ranges cannot be saved. They are permanent.

Duplicate AutoRange ranges cannot be saved. A duplicate AutoRange range is a range that has the same measurement mode and full scale and uses the same Q-RPT as a range that has already been saved.

3.4.1.2DELETING AUTORANGE RANGES

OPERATION

To delete a single saved AutoRange range, press [SETUP], <1range>, <2delete>. If there are any saved ranges available to delete, the display is:

1.Indication that the cursor control keys may be used to toggle through the saved ranges to select the one to be deleted.

2.Designator and position of the Q-RPT used by the range to be deleted.

3.Pressure unit of measure of the range to be deleted.

4.Full scale pressure of the range to be deleted in gauge mode and absolute mode if available.

<and > A700K Hi kPa 300g/100a

Use the cursor control keys to toggle through the ranges available to be deleted. When the desired range to be deleted is displayed, press [ENT]. If you are sure you want to delete this range, press [ENT] again in response to the <Delete?> query. [ESC] returns to the <AutoRange:> screen without deleting a range.

To delete all of the saved AutoRange ranges, press [SETUP], <1range>, <3delete all>. If you are sure you want to delete all the ranges, respond <1yes> to the <Delete all saved ranges?> query. If not, respond <2no>.

3.4.2 <2RES> (RESOLUTION)

PURPOSE

To set the resolution with which measured pressures and other pressure indications and settings are displayed.

PRINCIPLE

The resolution with which RPM4 displays pressure values can be adjusted. This feature can be used to reduce the resolution when lower precision measurements are being made and excess resolution might confuse or distract the operator.

The resolution setting determines the number of digits with which pressure is displayed. The resolution is calculated based on the span of the range and then rounded to the furthest

Page 53 © 2004-2007 DH Instruments, a Fluke Company