Fluke RPM4 manual Table of Contents

TABLE OF CONTENTS

TABLE OF CONTENTS

TABLE OF CONTENTS				I
TABLES				V
FIGURES				VI
ABOUT THIS MANUAL				VII
1 .	INTRODUCTION			1
	1.1	PRODUCT OVERVIEW		1
	1.2	SPECIFICATIONS		2
		1.2.1	GENERAL SPECIFICATIONS	2
		1.2.2	PRESSURE MEASUREMENT SPECIFICATIONS	2
		1.2.2.1	QUARTZ REFERENCE PRESSURE TRANSDUCER (Q-RPT)	2
		1.2.2.2	ON-BOARD BAROMETER	4
		1.2.3	BATTERY AND CHARGER PACK	5
2 .	INSTALLATION			7
	2.1	UNPACKING AND INSPECTION		7
		2.1.1	REMOVING FROM PACKAGING	7
		2.1.2	INSPECTING CONTENTS	7
	2.2	SITE REQUIREMENTS		8
	2.3	SETUP		8
		2.3.1	PREPARING FOR OPERATION	8
		2.3.2	FRONT AND REAR PANELS	8
		2.3.2.1	FRONT PANEL	8
		2.3.2.2	REAR PANEL	9
		2.3.3	POWER CONNECTION	9
		2.3.3.1	85 TO 264 VAC, 50/60 HZ VAC POWER	9
		2.3.3.2	BATTERY PACK	9
		2.3.4	REMOTE [ENT] CONNECTION (FOOTSWITCH OR OTHER SWITCH)	10
		2.3.5	CONNECTING TO MEASURE PRESSURE (TEST(+) AND TEST(-) PORTS)	10
		2.3.6	THE VENT OR ATM PORT	11
		2.3.7	CHECK/SET SECURITY LEVEL	11
		2.3.8	TURN OFF ABSOLUTE AND NEGATIVE GAUGE MODE (AXXX RPT)	12
		2.3.9	SDS FULL TIME OFF	12
		2.3.10	PARALLEL MEASUREMENT MODE	12
	2.4	POWER-UP AND VERIFICATION		12
		2.4.1	SWITCH POWER ON	12
		2.4.2	CHECK PRESSURE MEASUREMENT OPERATION	13
		2.4.2.1	CHECKING ABSOLUTE MODE PRESSURE MEASUREMENT	13
		2.4.2.2	CHECKING GAUGE MODE PRESSURE MEASUREMENT	13
	2.5	SHORT TERM STORAGE		14
3 .	OPERATION			15
	3.1	USER INTERFACE		15
		3.1.1	MAIN RUN SCREEN	15
		3.1.2	FUNCTION / DATA KEYPAD LAYOUT AND PROTOCOL	17
		3.1.3	REMOTE [ENT] (ENTER) FOOTSWITCH	18
		3.1.4	SOUNDS	18
	3.2	GENERAL OPERATING PRINCIPLES		18
		3.2.1	PRESSURE READY/NOT READY	18

Page I © 2004-2007 DH Instruments, a Fluke Company