3. OPERATION

Internally, RPM4 always operates in Pascal (Pa), the SI unit of pressure. Values of pressure are represented in other units by the application of conversion factors to convert from Pa (see Section 7.2.1).

OPERATION

To change the active pressure unit of measure for a range, press [UNIT] from the MAIN RUN screen while the range is active. The display is:

1kPa 2Pa 3MPa 4hPa 5bar 6mbar

The cursor is on the number corresponding to the active pressure unit of measure for the active range.

To change the pressure unit of measure, select the desired unit. Making the selection returns to the MAIN RUN screen with the selected unit active.

The pressure unit of measure selected is range specific. When in a given range, all functions and settings are represented in the current measurement unit for that range. However, certain internal and/or metrological functions (e.g., Q-RPT calibration coefficients) are always represented in Pa regardless of the current range unit. When the current unit is an altitude unit, the range and upper limit indications are in kPa if the unit is meters (m) and psi if the unit is feet (ft).

See Section 7.2.1 for tables of the conversion factors used by RPM4.

If the pressure unit selected is inWa (inches of water), the reference temperature for water density must we specified in a separate menu (choices are 4ºC, 20ºC 60ºF). No reference temperature selection is necessary for the unit mmWa as the only reference temperature commonly used for mmWa is 4 ºC.

The default pressure units of measure available under the UNIT function depend on whether the RPM4 has been set up as an SI or US version (indicated by SI or US at bottom right of introduction screen). The choice of six units available under the UNIT function can be customized from a wider selection by the user (see Section 3.5.6). The units available under the UNIT function can be reset to default by reset (see Section 3.5.9.2).

3.3.3 [MODE]

PURPOSE

To set the measurement mode (absolute, gauge, negative gauge or differential) for the active range.

For information on selecting the unit of measure, see Section 3.3.2.

PRINCIPLE

RPM4 supports simple, one-step switching between up to four different measurement modes:

Absolute

Measures pressure relative to vacuum (zero is hard vacuum). Range is

 

from zero absolute to full scale.

Page 27

© 2004-2007 DH Instruments, a Fluke Company

Page 37
Image 37
Fluke RPM4 manual Mode, 1kPa 2Pa 3MPa 4hPa 5bar 6mbar, Absolute