Fujitsu FI-6670A 175

Chapter 9 Operational Settings

Configuring the Data Transfer Width [SCSI Bus Width]

You can configure the width of data transfer when your computer is connected to the scanner via SCSI Connector 2 on the CGA Board.

1 Start up the Software Operation Panel.

Refer to "9.1 Starting Up the Software Operation Panel" (on page 156).

Scan Setting for Documents with Tabs or Non- Rectangular Documents

[Scan Setting for Documents with Tab (Automatic Paper Size Detection)]

When configuring settings to scan a non-rectangular document with a tab (index) or tab (index) sticker at the its bottom, you can scan and include such a tab or tab sticker in the scanned image when [Automatic Paper Size Detection] is selected.

2 From the tree listing on the left, select [Device Setting 2]	1
D [SCSI Bus Width].	1	Start up the Software Operation Panel.
		Refer to "9.1 Starting Up the Software Operation Panel" (on page
		156).
	2	From the tree listing on the left, select [Device Setting 2]
		D [Scan Setting for Documents with Tab (Automatic Paper

Size Detection)].

3 Select [16 bit(Wide)] or [8 bit].

Select [8 bit] if using any SCSI card or SCSI cable that ！ does not support Ultra Wide SCSI.

How to Use ScandAll PRO

175