1.4 Turning the Scanner ON and OFF
This section describes how to turn the scanner ON and OFF.
Turning the Scanner ON
The following shows the procedure for turning the scanner ON.
For a SCSI cable connection, be sure to turn on your computer
！AFTER turning on the scanner, and making sure number "1" indicates on the Function Number Display.
1 Press the "I" side of the Main Power Switch.
2 Press the [Power] button on the Operator Panel.
Flatbed type | Check | |
|
| Function |
[Power] Button | Send to | |
ADF type |
| Scan / Stop |
|
| |
Function |
|
|
Scan / Stop | Power | Power |
| ||
Check |
|
|
Send to |
|
|
⇒The scanner is turned on, and the Power LED lights in green.
Note that, while the scanner is being initialized, the Function Number Display changes as follows: "8" D "P" D "1", where "1" means the scanner is in the Ready Status.
Use the Main Power Switch to turn the power ON if the
Operator Panel power switch has been disabled.
For details, refer to "9.7 Settings Related to Power ON/
Turning the Scanner OFF
The following shows the procedure for turning the scanner OFF.
1 Press the [Power] button on the Operator Panel for more than 2 seconds.
⇒The power is turned off and the Power LED goes off.
•If you will not use the scanner for a long time, press the "O" side of the Main Power Switch to turn the power OFF. Then, unplug the scanner from the power outlet.
•Use the Main Power Switch to turn the power OFF if the Operator Panel power switch has been disabled. For details, refer to "9.7 Settings Related to Power ON/ OFF Control" (on page 188).
31