PCI expansion cards

6 Push the top of the card retention clip for the slot you are using down slightly, then rotate it out the back of the case to open it.

7 If necessary, remove the expansion slot cover for the slot you are using by sliding it up from inside the chassis.

8 Align the card with the slot, then press down to seat the card in the slot. If you are installing a full-length card, slide the front of the card into the front PCI card guide.

9

10

You can slightly rock the card end-to-end to seat it, but do not bend the card sideways.

Rotate the card retention clip into the chassis to the closed position.

Connect any required cabling to the card.

Some accessory/option card outputs exceed Class 2 or power source

Caution limits and therefore must use appropriate interconnecting cabling in accordance with the national electrical code during installation.

11 Enable the new PCI card:

If you are using the operating system hot-plug interface wait for the interface to appear on your monitor, then confirm the device to be enabled.

- OR -

www.gateway.com

103