
Configuring SCSI features
To access and change the Adapter Properties List:
1 Follow the instructions in “To access the LSI Logic MPT SCSI Setup Utility:” on page 27.
2 Use the up and down arrow keys to highlight the adapter to be configured, then press ENTER. The following message will be displayed:
Scanning for devices...Important | If the RAID on MotherBoard (ROMB) feature is not enabled, the | |
following message will be displayed: | ||
|
Current firmware does not support IME RAID type. Press any key to continue.
When the utility is finished scanning for devices, the Adapter Properties screen opens.
3 Use the up and down arrow keys to select options from the list and +/- to change the settings:
■<Device Properties> Takes you to the Device Properties screen
■Host SCSI ID (0 to 15)
■SCSI Bus Scan Order (Low to High (0 - Max) or High to Low (Max - 0))
■Removable Media Support (None, Boot Drive Only, or With Media Installed)
■CHS (Cylinder Head Sector) Mapping (SCSI Plug and Play Mapping or Alternate CHS Mapping)
■Spinup Delay (Secs) (1 to 15)
www.gateway.com | 31 |