Reconnect all cables to the SCSI hot-swap backplane.

Replacing the SCSI hot-swap backplane

12 Remove the new SCSI hot-swap backplane from its package, then place it in the chassis by engaging the bottom three slots in the board with the three lower retention tabs in the chassis.

13 Move the top of the board forward, engaging the rest of the slots with the other retention tabs on the chassis, until all ten tabs are through the ten slots in the board.

14 Slide the SCSI hot-swap backplane board down until the board is firmly in place on the chassis and the blue, spring-loaded plunger is fully seated.

15

16 Reinstall the system board by following the instructions in “Replacing the system board” on page 149.

17 Reinstall the center brace by following the instructions in “Removing and installing the center brace” on page 69.

18 Reinstall all PCI expansion cards by following the instructions in “Cold installation or removal of PCI expansion cards” on page 104.

19 Reinstall all memory boards and memory board air baffles by following the instructions in “Installing and removing memory boards” on page 85.

www.gateway.com

141