|
|
|
| Fibre channel module | |
|
|
|
|
| |
Activity | Green LED | Orange LED | Red LED | ||
|
|
|
|
|
|
2 | Gbps link established | Two flashes every 4 | Off | Off | |
|
| seconds |
|
|
|
|
|
|
|
|
|
2 | Gbps activity | Two flashes every 4 | On | Off | |
|
| seconds |
|
|
|
|
|
|
|
| |
Firmware error | Varies | Varies | On | ||
|
|
|
|
| |
Beacon* | Constant flash | Constant flash | Constant flash | ||
|
|
|
|
|
|
* Beacon is used by the Qlogic SANSurfer FE HBA Manager software to identify a specific adapter in the system.
Option ROMDuring the initial boot after installation of the fibre channel module, you will see the following information displayed during the POST:
QLogic CorporationQLA2322 PCI Fibre Channel ROM BIOS Version x.xx Subsystem Vendor ID 8086 Copyright (C) QLogic Corporation
Only enable the Option ROM if your primary boot device is attached to the fibre channel module in your server.
Operating system driver installation and configuration
Refer to the readme.txt file included with the drive for specific information on installation. For information on driver parameters, refer to Section 2, “Driver Parameters,” in the QLogic document Troubleshooting Guide 2Gbps Fibre Channel Host Bus Adapters, available from
www.gateway.com | 107 |