
Processors
4 Remove the memory boards or memory board air baffles from memory slots C and D by following the instructions in “Installing and removing memory boards” on page 85.
5 Remove the fibre channel module by following the instructions in “Installing or removing the fibre channel module” on page 108.
6 If you are installing the VRM for the fourth processor, remove the VRM air baffle by pushing down on the top of the baffle and pulling the baffle away at an angle from the center brace.
7 Pull the plastic tabs away from the sides of the VRM socket.
8 Holding the VRM by the edges, align the notch on the bottom edge of the VRM with the notch in the VRM socket and press the VRM firmly into the socket.
Do not use excessive force if the VRM converter does not install
Caution easily. The notch in the VRM and the tab in the VRM socket are designed to prevent incorrect installation. Forcing the wrong VRM into the socket, or forcing the correct VRM into the socket incorrectly, could result in damage to the VRM or the socket.
9 Make sure the tabs on the sides of the VRM socket close securely.
www.gateway.com | 121 |