Connect the chassis intrusion switch cable to the system board. Connect the internal SCSI connector to the system board. Install the plastic PCI dividers onto the system board.

Replacing the system board

16 Pull up the blue, spring-loaded plunger in the center of the board and slide the board toward the back of the chassis until the I/O connectors engage the back panel, then release the plunger.

17 Connect the three-cable bundle from the power distribution board to the power connectors on the system board (see “System board” on page 5).

18

19

20

21 Install the center brace by following the instructions in “Removing and installing the center brace” on page 69.

www.gateway.com

151