Configure the following parameters:
Parameter | Description |
Local Switch Type | Specifies the ISDN switch type used by your |
| ISDN service provider. |
| North American firmware: For most |
| locations, the default North America (Auto- |
| Detect) should be used. If the ISDN Switch |
| Type cannot be automatically detected, |
| specify National |
| (5ESS) |
| International (Excluding North America) |
| firmware: Europe (Euro ISDN), Japan |
| |
| Note: Australia has two switch types |
| available: TPH1962 (Microlink) and Euro |
| ISDN (Onramp); indicate the appropriate |
| type. |
Connect using this | Specifies the ISDN connection protocol you |
protocol | want to use (it must match the protocol on |
| the receiving system). For most connections, |
| Multilink PPP should be used. If it is not |
| supported, PPP for single |
| connections, V.120 and V.110 can be used. |
| Both PPP and Multilink PPP require that a |
| PPP communications stack be installed on |
| your computer. |
| If your workstation is configured as a |
| Windows for Workgroups Remote Access |
| Service (RAS) client, you must configure |
| the V.120 rate adaption protocol on both the |
| DIVA T/A workstation and on the remote |
| device (RAS Server ISDN adapter). |
| Continued next page… |
