Chapter 8. PROGRAM SETUP

When the event is a code event

(1)In the set value display state, move to the event item to be set for the segment on the programming map.

(2)Press the ENTER key to make display panel 1 flash (registration of first setting).

(3)Use the , , , and keys to make the first setting – setting the event output code.

Setting range :0 to 2n – 1

(n indicates the number of output points set in event configuration 1 auxiliary setting 1.)

(4)Press the ENTER key to stop the flashing on display panel 1.

(Pressing the FUNC and CLR keys causes display panel 1 to return to unset state “-----” and the flashing stops.)

Display (code event)

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Unset values are indicated as “-----”.

NOTE

Code events use one subfunction. A subfunction cannot be used when a setting has not been made “-----”.

Events that follow the event number of a code event (number of output points less 1) are skipped and not displayed.

8-9

Page 144
Image 144
Honeywell DCP552 Mark II user manual When the event is a code event, Display code event