Honeywell DCP552 Mark II user manual Selecting programs, BCD system

Chapter 6. OPERATION

•The on and off states of SW15 and SW16 determine whether external SW1 to SW14 operations are enabled or disabled. Note, however, that the autoload function and the O2 sensor check function cannot be disabled by SW15 and SW16.

￿￿￿

￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

■Selecting programs

•Programs can be selected using the external switches in the READY program run mode.

•Programs are selected using the external switches and the BCD system or the binary system, and are set in setup data C75. In the BCD system, four switches SW9 to 12 are used to set the one digit and the two switches SW13 to 14 are used to set the ten digit. In the binary system, six switches SW9 to 14 are used to set. Settings made with these systems are shown in the tables below.

●BCD system

!￿￿￿!￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿"￿% ￿￿￿￿￿￿￿￿￿￿￿￿￿&￿￿￿￿##￿￿$$$$###!#!#￿￿￿$$￿￿￿￿￿￿$$##!#!#!$$￿$$##!￿￿￿$$##!#!$￿￿￿￿￿￿￿$#'$$##!#!#$($#$)$#!&$$##!%$$

6-13