Honeywell DCP552 Mark II user manual PID parameter oL, oH are valid when setup

Chapter 5. FUNCTIONS

●Voltage, Open collector output (with setup data C21 set between 2 to 5)

Initialization of PID control computation

Setting: variable parameter PA17, PA43

		Setting: PID paramete P / l / d / rE (for CH1)
PID control computation
			Setup data C23
		Setting: variable parameter PA14
Output deviation limiter
		Setting: PID parameter oL / oH (for CH1)
Upper and lower output limiter
				Setting: variable parameter PA16
			ON-OFF control computation
				(PID parameter oL, oH are valid when setup
	During ON-OFF control			data C21 is set to 3 or 5.)
				Setting: variable parameter PA08, PA09, PA10
			AT computation
				(Variable parameter PA09 and PA10 are valid
	During AT executing			when setup data C21 is set to 3 or 5,
				respectively.)

Manipulated variable during overrange

Setting: setup data C33, C34

During overrange

Manipulated variable in READY mode

In READY mode

Setting: setup data C32

Preset MANUAL value Setting: setup data C35, C36

MANUAL Manipulated variable

In MANUAL mode

Manipulated variable (MV1)
	Setting: variable parameter PA15
Output 1 time proportional
output cycle	Setup data C93
	(ON-OFF control and AT execution are valid
	when setup data C21 is set to 2 or 4, respectively.)

Output voltage 1 control

Output 1

(During 6D output) Setting: setup data C95

Voltage time proportional output Proportional output when open collector is on

5-33