Chapter 8. PROGRAM SETUP
●Description of numbered items in the figure illustrating the program setting state
(1)Programming is started. Up to about 1 second after the programming state is entered, the remaining number of segments is displayed in display panel 1 and the remaining number of subfunctions is displayed in display panel number 2. The display can be held by pressing the FUNC key.
(2)Move the setting items on the programming map.
(3)Move the segments on the programming map.
(4)Register the first setting.
(5)Increase or decrease the values in the first setting and move the flashing digits.
(6)Complete the registration of the first setting.
Pressing the ENTER key registers the set value in memory.
For items with a second setting, the registration state for the second item is displayed. The display reverts to display set values for items without a second setting. Pressing the FUNC and CLR keys returns a segment to its initial state.
(7)Use the FUNC and ENTER keys in pattern items to go between
Note, however, that a changeover cannot be made when a segment is running.
(8)Use the FUNC and CLR keys in pattern items to display “CLEAr ” to delete the program beyond that segment.
Note, however, that the FUNC and CLR keys are invalid when a program is running.
(9)When the ENTER keys is used, the program beyond the point where the key was pressed is deleted. Pressing the DISP key does not delete any data but causes the display to show set values.
(10)Increase or decrease the values in the second setting and move the flashing digits.
(11)Complete the registration of the second setting.
Pressing the ENTER keys registers the set value in memory.
Pressing the FUNC and CLR keys returns a segment to its initial state.
(12)Complete the registration without entering the value in memory.
(13)Pressing the FUNC and ENTER keys in pattern items displays the segment insertion and deletion panel “InS.” flashes.
Note, however, that the FUNC and ENTER keys are invalid when a program is running.
(14)Use the ↓ key to delete and the ↑ key to insert the flashing item.
(15)Pressing the ENTER keys when “InS.” is displayed inserts the segment. Pressing the ENTER keys when “dEL.” is displayed deletes the segment. Pressing the DISP key neither deletes or inserts the segment.
(16)Press the FUNC and PROG keys so that the program number starts to flash.
(17)Program numbers and segment numbers can be increased or decreased and the moving digits can be moved.
(18)Pressing the ENTER keys completes the registration of program and |
|
segment numbers. |
|
(19)The normal display mode appears. |
|
(20)Change chanells. | |
|
