Master Programming Level

Programming

3.5 Master Programming Level

When the Master Program Level password is entered, the control panel will enter user Programming mode. In this mode, the piezo sounder remains off, the trouble relay is activated and the system Trouble indicator flashes until Programming mode is exited. The following display will appear:

PROGRAMMING

1=FACP CONFIG T6 2=INPUT ZONES 3=OUTPUT CIRCUITS

Programming Screen #1

The down arrow which appears in the display indicates that additional programming choices can be viewed by pressing the down arrow key on the keypad. If a down and up arrow appear in the display, pressing the ‘down’ arrow key will display the subsequent Programming Screens as illustrated below while pressing the ‘up’ arrow key will display the previous screen.

PROGRAMMING

1=CROSS INPUT ZONES 2=ON-BOARD RELAYS 3=SYSTEM SETUP

Programming Screen #2

PROGRAMMING 1=ANN-BUS 2=HISTORY 256 EVENTS 3=WALKTEST

Programming Screen #3

PROGRAMMING 1=CLEAR PROGRAM 2=PASSWORD CHANGE

Programming Screen #4

MRP-2001 & MRP-2001E PN 53040:A 4/16/2007

49