Programming
PROGRAMMING
1=FACP CONFIG USER 2=INPUT ZONES 3=OUTPUT CIRCUITS
Programming Screen #1
Master Programming Level
3.5.1 FACP CONFIG (Application Templates)For a detailed description of each Template, refer to "FACP Configuration Templates" on page 108. The FACP Configuration option allows the user to program the FACP with one of seven factory preprogrammed templates or one custom template which can be programmed by the user. The templates have been provided to allow the user to quickly program the panel with typical job- site configurations. The user may choose to select one of the templates or bypass this option, proceeding to the next sections which detail customized programming of the FACP.
A factory template may be chosen and later changed to better fit a site requirement. The changed template can be saved as the one custom template.
Pressing 1, while viewing Programming Screen #1, will select the FACP Config option and display the following screen:
FACP CONFIG1=N/A2=N/A3=N/AFACP Config Screen #1
Pressing the down arrow key will display screens for additional Templates and the Custom Template. During initialization of the panel following
Note: Only Templates 7 through 13 are available for the
To select a
The Input Zones option allows the user to initially program or change the programming for the six input zones (circuits). Pressing 2, while viewing Programming Screen #1, will select the Input Zones option and display a screen similar to the following:
INPUT ZONES 1=ZONE 1 2=ZONE 2 3=ZONE 3Input Zone Screen #1
Pressing the down arrow key will display additional screens for Input Zones 4 through 6. To program a specific zone, press the number key corresponding to the desired zone while viewing one of the Input Zone screens.
To program Input Zone 1, press the 1 key while viewing Input Zone Screen #1. The following screens will be displayed:
INPUT ZONE 1
Normal PULL STATIONPRESS
TO EDITEdit Input Zone Screen #1
50 |