HP 2/8q Fibre Channel Load Firmware dialog box messages, Port Loopback Test dialog box messages

Switch Manager

Load Firmware dialog box messages

Table 34: Load Firmware dialog box messages
Message	User action
Bad checksum/CRC for the firmware image or	Select the correct firmware file for this switch.
incorrect firmware image for this type of
switch.
File was not found.	Verify that the firmware file specified actually
	exists, or specify a new firmware file.
Firmware image had a bad CRC or was	Select a valid firmware image for this type of
invalid for this type of switch.	switch and retry the operation.
Firmware upload status unknown. Image has	The application lost communications with the
been uploaded, but confirmation from the	switch while the switch was unpacking the
switch was not received.	firmware image. If the problem was
	temporary, examine the firmware versions on
	the switch to verify that the firmware was
	unpacked correctly, or upload a new firmware
	image to the switch.
The flash memory on the switch may be too	Select an appropriate firmware image for this
small for this image.	type of switch and retry the operation.
Unable to load firmware.	An unspecified error has occurred. Verify that
	the user has permissions to modify the
	configuration on the switch, that the switch is
	reachable in the fabric, and that the fabric is
	reachable from the user’s workstation, and
	then retry the firmware upload.
Unable to read file.	Verify that the firmware file specified exists
	and is readable by the user, on a file system
	readable by the user, or specify a new
	firmware file.

Port Loopback Test dialog box messages

Table 35: Port Loopback test dialog box messages

Message	User action
Attempt to put port in diagnostic state has	Verify that the user has permissions to modify
failed. Unable to continue with port test.	the configuration on the switch, that the switch
	is reachable in the fabric, and that the fabric is
	reachable from the user’s workstation, and
	then retry the configuration change.
External port test requires a loopback device	Verify that a loopback device is attached to the
be plugged into the selected port. Click “OK”	port before starting loopback test.
when loopback device is installed.
Failed to correctly restore port states for one or	Return to the faceplate view and then select
more ports.	View>Port State to determine which port was
	not restored to its original state. Select the
	port, and then select Port>Port Properties to
	restore the port state.
Invalid frame count value.	Verify that all information is valid, and then
or	retry the loopback test.
Invalid frame size. Must be 36 to 2148.
or
Invalid hex pattern. Up to 8 hex digits
allowed.

104 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide